This type of flow sensor is used to measure liquid flow within a pipe and is ideally suited for monitoring water consumption in irrigation control systems. Each side of the sensor has a 1/2″ NPS nominal pipe connections, 0.78″ outer diameter, 1/2″ of thread. The sensor is connected by way of a 3 pin connector.
Inside the housing, a small pinwheel with an attached magnet is spun by passing water; as the magnet makes each revolution, a hall effect sensor inside the housing outputs a pulse on the yellow wire. Each pulse output represents approximately 2.25mL of fluid. The sensor is best suited to flow rates between 1 and 30 liters per minute – flow rates below one liter per minute tend not to register accurately.
Working Voltage: 3.5 to 24VDC
Max current draw: 15mA @ 5V
Working Flow Rate: 1 to 30 Liters/Minute
Working Temperature range: 1°C to 80°C
Maximum water pressure: 1.75 MPa
Output duty cycle: 50% +-10%
Output rise time: 0.04us
Output fall time: 0.18us
Durability: minimum 300,000 cycles
Pulses per Liter: 450
*Prices subject to change without notice. We reserve the right to limit quantities.
-
Part No
YF-S201
-
Manufacturer
-
Stock No
MZM-102
-
SKU No
270857
To purchase bulk quantities, Please contact our Sales Department
(+1-416-494-8999) or email shop@sayal.com
